A small high-pressure unit designed to destructive and non destructive pressure tests of the products like castings, piping systems, pressure vessels, heat exchangers, pressure bottles, etc.
High pressure NDT or DT of products, castings, fittings, fittings, fittings, pumps, pressure vessels (aerators, vents, expanders, storage tanks, water heaters, drainage vessels, venting vessels, etc.), steam turbines and boilers , fire-fighting equipment and fire-fighting vessels, tubes and heat exchangers.
|
Technical name |
AQTA 2.2 - 280/4 |
|
Max. pressure |
280 bar |
|
Max. flow |
4 l / min |
|
Performance |
2.2 kW |
|
Weight |
About 60 kg |
|
Speed |
940 rpm |
|
Dimensions |
750 x 320 x 450 mm |
Speck three plunger pump, electric motor, common frame, pressure regulator, low-pressure suction pressure gauge with pressure sensor for pressure and flow, glycerin damped high pressure gauge, inlet water filter, pressure switch - suction pressure, , clutch, clutch cover, engine starter and fork cable.
The pressure and flow control can be manually adjusted on the pressure regulator in the basic version. After start of pressurization start by motor starter, connection of discharge to pressure object (VT hose &ute;) and filling the pressurized object with a liquid draws the pressure regulator only after reaching the desired pressure. Excessive fluid forgives the pressure regulator. After pressurization it is advisable to close the pressure object by the closing armature. For further pressure to the same pressure, it is possible to keep the pressure regulator set to the final value of the previous pressure.
